Construction Adhesives

Application Guidelines

Application Temperature:

0°F to 100°F

Service Temperature Range:

-20°F to 120°F

Working Time:

Approximately 15 minutes for a 1/4" bead

Prep:

Surfaces must be clean and free of any material that may prevent adequate adhesion.

Application:

Cut tip on slant for 1/4” to 3/8” bead. For subfloors, cut tip straight across. Puncture inner seal and place in cartridge gun. Apply adhesive to one of the surfaces in either a continuous or spot bead. Adhere materials within 15 minutes. Press surfaces firmly together with a slight twisting motion. Certain large applications may require additional bracing until adhesive has dried. Note: For subfloors, apply adhesive to joists for one sheet at a time. Nail or screw each sheet as recommended by the American Plywood Association.

Cleanup:

Tools and adhesive may be cleaned with acetone or mineral spirits. Follow solvent vendor’s precautions.

Limitations:

Not designed for continuous submersion or for use on plastics, polystyrene or polyethylene foams. Do not adhere one non-porous material to another since this will slow or prevent drying.